Hole Saw Type Introduction
morse Saw Blade---Hole Saw Master Cobalt® Bi-Metal Standard hole saw Cuts all machinable metals including stainless steel, wood, nailed wood, plastics, synthetic glass, drywall, fiberboard and composite materials. The standard cutting depth is 1-1/2", and it can cut workpieces with a size of 2*4'S. It needs to be configured with an axis to operate. Real McCoy® Bi-Metal Hole Saw Cuts all machinable metals including stainless steel, wood, nailed wood, plastics, synthetic glass, drywall, fiberboard and composite materials. The standard cutting depth is 1-1/2", which can cut workpieces with a size of 2*4'S. No additional shaft is required for operation. Master Cobalt® Bi-Metal Deep Duty Hole Saw The range of applications is the same as for the Master Cobalt® bimetal standard hole saw. However, the cutting depth is larger, reaching 1-7/8". It also needs to be configured with a shaft to operate. Real McCoy® TAD Bi-Metal Deep Cutting Hole Saw The range of applications is the same as the Real McCoy® bi-metal TA hole saw. However, the cutting depth is larger, reaching 1-7/8". No shaft configuration is required for operation.
Tungsten Carbide Hole Saw Cuts wood, plastic, aluminum, steel, synthetic glass, drywall, fiberboard, plaster, tile, countertops without nails. Compared with bi-metal hole saws, it has a coarse pitch and is suitable for high-speed cutting of soft materials, not suitable for cutting pipes. Standard depth of cut is 1-1/2". Shaft configuration is required for operation. Real McCoy® Bi-metal Hole Saw Kit The kit includes all sizes of hole saws commonly used by Real McCoy® professionals and is easy to carry. Tungsten Carbide Hole Saw Carbon Steel Hole Saw cuts very hard materials, including hardened steel, cast iron, brick, clinker, ceramic, foam glass, synthetic glass, composites, computer room floors, cement, ceramic tile. The standard depth of cut is 1-1/2"; and requires a shaft to be configured for operation. flat drill Can cut wood, plastic, plywood, bakelite. High speed and deep cutting at any angle. Master Cobalt® Bi-Metal Hole Saw Set The set includes all sizes of hole saws commonly used by Master Cobalt® professionals, and the Hole Saw Set Bi-Metal is easy to carry. Reaming Bits/Grading Drills Can cut sheet metal, plastic, plexiglass, PVC, synthetic board, gypsum board. Used to drill or enlarge holes, and can also be used to smooth out burrs during automatic rust prevention. Shafts, Shaft Sets, Center Drills, Other Parts The shaft made of carbon steel is matched with the pilot drill. Makes the Morse hole saw usable with any professionally used power drill.
